1-30 1. Overview
Multi-link2 (Ethernet) table
Wiring
The connection between the master and the PLC is the same as the one for 1 : n connection. Refer to “ Wiring” (page 1-15) in
“ 1:n Connection (Multi-drop)”.
Use a LAN cable to connect a master with slaves.
Item Contents
Multi-link2 (Ethernet) Table
For local port 1 (master)
Set the IP addresses of all V9 units used as slave to respective local port numbers.
For local port 2 to 32 (slave)
Set the IP address of the master V9 for No. 1.
To Next Page
Loading...