1.3 Connection Methods 1-39
*1 For more information on each setting item, see “ Basics of ethernet settings” (page 1-51).
Settings in Local Mode on the V9 Unit
Set the IP address in Local mode on the V9 unit.
If IP address setting has been performed on the V-SFT editor, this setting will be taken as the valid one.
1. Press the [SYSTEM] switch on MONITOUCH to display the system menu.
2. Press the [Local] switch. The display switches to Local mode.
3. Press the [LAN Setting] switch and display the LAN Setting screen.
4. Set each item.
5. Press the [Apply] switch to determine the setting.
* Press the [Return to Screen Data Setting] to return to the settings made on the V-SFT editor.
Send Timeout Specify the timeout time to send the EREAD/EWRITE/SEND/MES command.
Retrials
0 to 255
Set the number of retrials to be performed when a time-out occurs.
Device Protect
Internal Device
Memory Card Device
Check either check box to write-protect the device memory from computers or other stations.
Item Contents
To Next Page
Loading...