1.4 Hardware Settings 1-53
Printer properties
Item Contents
Printer Control Device
When this setting is enabled and the bit is set to ON (0 1), screen images and data sheets
can be printed out.
Printer Info Output Device
When this setting is enabled, the status of the printer is stored in the specified address.
Always Output Status Bit
The V9 series outputs [0 1] when starting to transfer data upon receiving a print command,
and outputs [1 0] upon finishing transfer. However, these signals may not be output if the
print data is small.
Select [Yes] to output a signal regardless of the data size.
The output area is as follows:
Bit 1 of the device memory for printer information output
Bit 0 of internal device memory $s16
Hard Copy
Orientation
Specify the printing orientation of the screen on paper.
In vertical output, the screen is rotated 90 clockwise with respect to the printing paper and
printed out.
Printing examples of hard copies:
Reversed Image
Reversed: Screens are printed with black and white inverted.
Normal: Screens are printed as they are displayed on MONITOUCH.
Data Sheet Data Sheet Setting
Make settings for printing data sheets. For more information, refer to the V9 Series Reference
Manual.
Use PictBridge only on USB-B port.
Make this setting when using a PictBridge-compatible printer.
Select [Yes] when starting up the USB-B port as the connection port for a PictBridge printer in
the RUN mode.
When transferring screen programs via the USB-B port, switch to Local mode.
To Next Page
Loading...