2.1 Temperature Controller/Servo/Inverter Connection 2-19
RCB-TU-SIO-A/B
PORT switch (PORT)
Emergency stop terminal block
When the servo cannot be turned on, connect the EMG switch between the EMG1 terminal and the EMG2 terminal on the
emergency stop terminal block.
When the EMG switch is not used, short-circuit them.
Available Device Memory
The available setting range of device memory varies depending on the model. Be sure to set within the range available for the
model to be used. Use [TYPE] when assigning indirect device memory for macro programs.
PORT Setting Remarks
ON
ON
SW1
Device Memory TYPE Remarks
Coil (coil) 00H
Register (holding register) 02H
To Next Page
Loading...