3 Copy
126
Copy
3
1 Select [Edge Erase].
2 Select any option.
îš„ Normal
The edge width to erase is set to 2 mm for the
top and bottom, and left and right edges.
îš„ All Edges
Erases the shadows of the four edges of a
document, as well as the shadow in the center
of the document if it is a bound document or a booklet. You can specify values for [All Edges]
and [Center] individually.
îš„ Individual Edges
Erases the shadows of the top, bottom, left, and right edges of a document, as well as the
shadow in the center of the document if it is a bound document or a booklet. You can specify
values for [Top], [Bottom], [Left], [Right], and [Center] individually.
îš„ Parallel Edges
Erases the shadows of the top and bottom edges, and left and right edges of a document,
as well as the shadow in the center of the document if it is a bound document or a booklet.
You can specify values for [Top & Bottom], [Left & Right], and [Center] individually.
îš„ Erase Value
Allows you to specify values to erase the edges of a document.
z
All Edges
Erases the shadows of the four edges of the document according to the orientation of the
loaded document. You can specify the edge width you want to erase in the range from 0
to 50 mm in 1 mm increments.
z
Top & Bottom (Top/Bottom)
Erases the shadows of top and bottom edges of the document according to the
orientation of the loaded document. You can specify the edge width you want to erase in
the range from 0 to 50 mm in 1 mm increments.
z
Left & Right (Left/Right)
Erases the shadows of left and right edges of the document according to the orientation
of the loaded document. You can specify the edge width you want to erase in the range
from 0 to 50 mm in 1 mm increments.
z
Center
Erases the shadow in the center of facing pages of a bound document or a booklet. You
can set the binding erase width in the range from 0 to 50 mm in 1mm increments.
îš„ Original Orientation
Allows you to specify the orientation of the document so that the machine can identify the
top of the document.
To Next Page
Loading...
Need help?
General
