Scan to PC
313
Scan
5
-[Type 1]
The buttons 1 to 70 are used for address numbers and they correspond to the registered address
numbers 0001 to 0070, while the buttons M01 and M02 are used for stored programs and
correspond to the registered stored programs 1 and 2.
-[Type 2]
The buttons 1 to 60 are used for address numbers and they correspond to the registered address
numbers 0001 to 0060, while the buttons 61 to 70, M01 and M02 are used for stored programs
and correspond to the registered stored programs 1 to 12.
1 Press a one-touch button. Confirm that the recipient (destination PC) specified with the
one-touch button is displayed on the touch screen.
Important • The one-touch buttons have a sensor to detect which page of one-touch buttons (1 - 24, 25 - 48, and
49 - M02) is currently opened. Before pressing a one-touch button, turn over the one-touch panel
completely, and take off your hand from the panel. Do not press the button while you are turning
over the panel.
• Do not place any objects near the one-touch buttons, nor spill any liquid over them.
Note • Turn the one-touch panel over to press the one-touch buttons 25 and above.
• If you have entered an incorrect value, select the recipient (destination PC) displayed on the touch
screen, select [Remove] on the pop-up menu, and enter the correct value.
Browse (Specifying a Destination PC by Browsing Your Network)
This feature displays a hierarchy consisting of server names and folders. You can specify a
save destination by tracing the hierarchy.
1 Select [Browse].
2 Select the destination to save the data in.
Select [Previous] or [Next] to move to another
level.
Important • You can specify recipients for SMB only.
Note • Scroll the list by drag or flick operation to
switch the screen to be displayed. For
information on how to drag or flick, refer to
"Touch Screen" (P.90).
To Next Page
Loading...
Need help?
General
