Regulation
31
Before Using the Machine
1
Regulation
Regulatory Information for RFID
Radio Frequency Emissions (Class B)
Product Safety Certification (CB)
This product contains Radio Frequency Identification system device (RFID)
and it is certified in compliance with applicable local laws and/or regulations.
This product has been tested and found to comply with the limits for a Class
B digital device, pursuant to the International Standard for Electromagnetic
Interference (CISPR Publ. 22) and Radiocommunications Act 1992 in
Australia/New Zealand. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
product generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this product does
cause harmful interference to radio or television reception, which can be
determined by turning this product off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
z
Reorient or relocate the receiving antenna.
z
Increase the separation between this product and the receiver.
z
Connect this product into an outlet on a circuit different from that to
which the receiver is connected.
z
Consult the dealer or an experienced radio/TV technician for help.
Changes and modifications to this product not specifically approved by Fuji
Xerox may void the user’s authority to operate this product.
This product is certified by the following agency using the safety standards
listed.
Standard
IEC 60950-1 2nd +A1
IEC 60825-1:2007(2nd Edition)
To Next Page
Loading...
Need help?
General
