2 Product Overview
74
Product Overview
2
Switching the Power On
The following describes how to switch the power on.
The machine takes approximately 30 seconds to warm up and to be ready to copy or print
after switching the power on. This may take more time depending on the configuration of
your machine.
Switch the power off at the end of the day or when not using the machine for an extended
period of time.
You can also use the Power Saver feature to save power consumption while the machine is
not in use.
For information on the Power Saver feature, refer to "Power Saver Mode" (P.79).
Important • If the power is switched off, all the services of the machine will stop. When using the machine
throughout the day for jobs such as receiving fax, do not switch the power off.
1 Press the push-button power switch to switch
the power on.
z
When the Finisher-B1 (optional) is installed
Note • The “Please wait...” message indicates that
the machine is warming up. The machine is
not available during warming up.
• If the machine does not power on, check the
following:
- The power cord is plugged in.
- The main power is switched on.
- The <RESET> button is set on and is in the
depressed position.
To Next Page
Loading...
Need help?
General
