3 Copy
160
Copy
3
Job Assembly
This section describes the features you can select on the [Job Assembly] screen. The
following shows the reference section for each feature.
Build Job (Processing Documents Scanned with Different Settings as One Job)......................................................... 160
Sample Job (Checking the Finished Output of the Copy) .................................................................................................. 164
Combine Original Sets (Adding Originals)............................................................................................................................. 165
Form Overlay (Making Copies to Overlay Documents)....................................................................................................... 166
Delete Outside/Delete Inside (Deleting Outside or Inside of the Selected Area) ........................................................ 166
Stored Programming (Calling a Stored Program for Build Job)....................................................................................... 168
1 Select [Copy] on the Services Home screen.
2 Select a feature on the [Job Assembly] screen.
Build Job
(Processing Documents Scanned with Different Settings as One Job)
This feature allows you to apply different copy settings to each document page or each
document stack, and then output the copies as one job.
1 Select [Build Job].
2 Select [On].
3 Select any option.
Note • Select [ ] to return to the previous screen or
[ ] to move to the next screen.
îš„ Off
Build Job is not applied.