1 Before Using the Machine
24
Before Using the Machine
1
Others
Do not incline the product at more than 10 degree angle. Otherwise, it may
fall over and cause injuries.
Right
Right
Left
Left
Front
Front
Back
Back
Always lock the wheels of this product after installation. Otherwise, it may
fall over or slide and cause injuries.
To bundle wires and cables, always use the cable ties and spiral tubes that
Fuji Xerox supplies. Otherwise, it may cause some defects.
To keep this product in a good performance and condition, always use it in
the following environment:
z
Temperature: 10 - 32°C
z
Humidity: 15 - 85%
When the product is left in a chilly room and the room is rapidly warmed up
by heater, dew condensation may form inside the product and cause a
partial deletion on printing.
To Next Page
Loading...
Need help?
General
