Scanning Procedure
263
Scan
5
2 Load the document face up (when the
document is 2-sided, place the front side up) in
the center of the document feeder.
3 uides to match the size of the document
loaded.
4 Open the document stopper.
Document Glass
The document glass supports a single sheet, a book, or other similar documents with a size
297 x 432 mm (Standard size: A3, 11 x 17").
Important • Always close the document cover after using the document glass.
The document glass automatically detects standard size documents. For non-standard size
documents, enter the size on the [Original Size] screen.
For information on document sizes that can be detected automatically and how to enter a non-standard document size,
refer to "Original Size (Specifying a Scan Size)" (P.338).
The standard document sizes that can be detected automatically depend on [Paper Size Settings] in the System
Administration mode. For information on the paper size settings, refer to "5 Tools" > "Common Service Settings" > "Other
Settings" > "Paper Size Settings" in the Administrator Guide.
Do not apply excessive force to hold thick document on the document glass. It may
break the glass and cause injuries.
To Next Page
Loading...
Need help?
General
