Error Code
339
Problem Solving
14
003-753
O [Cause] The mixed sized document was to be scanned with high
resolution using the 2-sided feature.
[Remedy] Set [Resolution] to [200dpi], and try again.
003-754
003-755
O [Cause] An error occurred in the document feeder.
[Remedy] Execute the job again.
003-756
O [Cause] The fax document is all blank.
[Remedy] Check whether or not the document is blank or the
document is correctly loaded.
003-757
O [Cause] The mixed sized document was to be scanned with high
resolution using the 2-sided feature.
[Remedy] Set [Resolution] to [300dpi] or lower, and try again.
003-760
O O [Cause] An incompatible combination of features are specified as
document scan conditions.
[Remedy] Check the selected options.
003-761
O O [Cause] The paper size of the tray selected for auto tray is different
from the paper size of the tray selected for Auto Tray
Switching.
[Remedy] Change the paper size for the tray, or change the [Paper
Type Priority] settings.
003-764
O [Cause] The scanned documents contains only one page for form
overlay function.
[Remedy] Make sure the document contains at least two pages.
003-780
O [Cause] Failed to compress the scanned document.
[Remedy] Reduce the resolution or the ratio for [Reduce/Enlarge] to
decrease the data size, or split the data to send it
separately.
003-795
O [Cause] When enlarging/reducing a scanned document to the
specified paper size, the reduction/enlargement ratio value
is out of allowed range.
[Remedy] Take one of the following actions:
z
Manually enter a reduction/enlargement ratio.
z
Change the paper size.
003-981
O [Cause] For a mixed size document, the stapling feature is
available for paper with the same width.
[Remedy] Cancel stapling or align the paper width for stapling.
005-210
O O [Cause] The document feeder settings failed.
[Remedy] Turn the machine off and on, then perform the same
operation again.
005-275
005-280
005-283
005-284
005-285
005-286
O O O [Cause] An error occurred in the document feeder.
[Remedy] Turn the machine off and on. If the error persists, contact
our Customer Support Center.
Error Code
Category
Cause and Remedy
CPFSMO
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
To Next Page
Loading...
Need help?
General
