14 Problem Solving
356
Problem Solving
14
016-774
O O O [Cause] Unable to process compression conversion due to
insufficient hard disk space.
[Remedy] Remove unnecessary data from the hard disk to increase
free disk space.
016-775
O O O [Cause] Unable to process image conversion due to insufficient
hard disk space.
[Remedy] Remove unnecessary data from the hard disk to increase
free disk space.
016-776
O O O [Cause] An error occurred during image conversion processing.
[Remedy] For error upon forwarding with Scan to Mailbox or Internet
Fax: The image conversion processing for the data may
be finished partially. Get each converted page from the
mailbox using CentreWare Internet Services.
For more information, refer to "Setting Items Using
CentreWare Internet Services" (P.197).
For error after instructing encryption or signature using
certificate:
Take one of the following actions:
z
Check if the certificate is valid.
z
Set the correct date and time on the machine.
016-777
O [Cause] A hard disk error occurred during image processing.
[Remedy] The hard disk may be defective. For replacing the hard
disk, contact our Customer Support Center.
016-778
O [Cause] The scanned image conversion processing was
interrupted, due to insufficient disk space.
[Remedy] Remove unnecessary data from the hard disk to increase
free disk space.
016-779
O [Cause] An error occurred during scanned image conversion
processing.
[Remedy] Retry scanning. If using large-size paper such as A3 with
[Resolution] set to 600dpi, specify [Resolution] to 400dpi
or less in [Layout Adjustment]. If the error persists, contact
our Customer Support Center.
016-780
O [Cause] A hard disk error occurred during scanned image
conversion processing.
[Remedy] The hard disk may be defective. For replacing the hard
disk, contact our Customer Support Center.
016-781
O [Cause] Unable to connect to the FTP server.
z
Unable to establish a connection between the machine
and the server.
z
The ASCII characters are not used for the host name
specified on the machine, though the connection
between the machine and the server has been
established.
[Remedy] Take one of the following actions:
z
Make sure the network cables are plugged in securely.
z
Enter the host name using ASCII characters in [Tools] >
[System Settings] > [Connectivity & Network Setup] >
[Machine’s E-mail Address/Host Name].
Error Code
Category
Cause and Remedy
CPFSMO
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
To Next Page
Loading...
