Getting started
Connecting the machine to the mains
Mainsadapt er,
2
1
► Connect the mains cable to the machine (1).
► Plug the mains plug into a three -pin socket (2).
Switching on for the first time: installing the software
Installing,Software,Installing,
If the device i s integrated into a network, the user and server details as well as the
network protocol are required during the software installation.
Contact your network administrator if you have any questions about these settings.
When you switch on the device for the first time, the supplied software is installed and configured.
Plan a reasonable amount of time for this, as this process must not be interrupted.
Once the installation has been started the device must not be switched
off, unless the installation has be en completed.
During installation, the device may only be rebooted when you are requested to do so!
The installation will otherwise n ot b e carried out correctly and the contents
of the hard disk must be completely restored.
You m ay need the licence numb er for Windows during the installation. The licence
number is located on a sticker on your device.
12 AMILO Desktop Operating Manual, edition 3
To Next Page
Loading...
Need help?
General
