Operation
Taking out the memory card
Memorycard,
When taking out the card, always proceed syste matically as described
below, to avoid any loss o f your data.
Always wait until the data a ccess has been comp leted before taking
the c ard out of the slot.
If your reader has a s tatu s display, remove the card only once this has stopped flashing.
1
2
► If your reader has a card interlock: Press
on the memory card (1).
Memorycard,
The memory card is now released
and can be taken out.
► Take the memory card out of the slot (2).
Displays on the machine
Operational d
isplay
Machine
The displays appear on the front of the casing.
The displays available for your machine depend on which expansion stage you have selected.
Memory card reader status display
• The display lights up continuously: A memory card has been inserted.
• The display flashes: The memory card is being accessed.
• The display rem ains unlit: There is no m emory card in the reader.
Operational display
Operatio
naldisplay
Do not disconnect the machine from the mains whilst in power-saving
mode, otherwise data may be lost.
• The display lights up white: The machine is switched on.
• The display flashes white: The mach ine is in p ower-saving mode. After switching
on at the on/off switch the machine switches on or reverts to the status it was
in before power-saving mode was initiated.
• The display flashes yellow: The hard disk is being accessed.
• The display remains unlit: The machine is not connected to the mains or is not ready for
operation. If the machine is ready for operation, it can be switched on at the on/off switch.
16 AMILO Desktop Operating Manual, edition 3
To Next Page
Loading...
Need help?
General
