Getting started
Connecting t he keyboard
You can connect a USB keyboa rd or a PS/2 keyboard to your device .
Keyboard,Connecting,
Connecting a USB keyboard
Use the supplied keyboard cable only.
USBport,Connecting,
► Plug the flat rectangu lar USB co nnector of the keyboard cable into a USB port of the device.
USBport
Connecting a PS/2 keyboard
Use the supplied keyboard cable only.
ConnectingaP S /2keybo
ard
Connecting,
The P S/2 keyboard is only detected b y the d evice if you connect the keyboa rd
when the device is switched off and then switch the device on again.
► Switch your device off.
► Plug the round plug of the keyboard cable into a keyboard port of the device.
Keyboard,
► Switch your device on again.
Connecting external devices to the parallel
(optional) or seri
al port
ParallelportSerialportParallelportSerialportExternaldevicesDevices
External devices ca n be connected to the parallel or serial port (e.g. a printer or a scanner).
► Connect the data cable to the external device.
► Depending on th
e device, connect the data cable to the parallel port or the serial port.
For an exact des
cription of how to connect exte rnal devices to the corresponding
port, please r
efer to the documentation of the external device.
Port settings
ParallelportSerialport,
You can change the port settings (e.g. add ress, interrupt) in the BIOS Setup.
Device drivers
Devicedrive rsDevice drivers,
The devices connected to the parallel or serial port require drivers. Your o perating
system already includes many drivers. If the required drive is missing, install it. Current
drivers are usua lly available on the Internet or will be supplied on a data carrier.
20 Fujitsu
To Next Page
Loading...
