System expansions
Installing and removing drives
in the
middle bay (optional)
In the middle bay you c an either
install one 3½ inch or two 2½ inch drives using
a 3½ inch adapter. A ccessible
drives here a re for exa mple SmartC ard or Multica rd
readers. Non-acce ssible dri
ves are hard disks or SSDs.
Fixture in t he casing is al
ways using screws.
Operation of a SmartCard r
eader with a RFID reader is not permitted in Taiwan.
The following procedure describes installation and removal using the examp le of a Multicard reader.
The approach is the same for all variants. Any differences are indicated accordingly.
Installing a 3½ inch
drive
• The casing cover is removed (see chapter "Removing the casing cover", Page 35).
• A suitable dri ve co
ver is mounted (see chapter "
Changing the drive cover", Page 38).
► Fold out the drive cage (see chapter "
Opening the drive cage", Page 46).
1
b
a
► When installing 2.5" HDDs/SSDs or a SmartCard reader: Connect the cables
to the drive before you slide it into the bay.
On the multicard re ader, one end of the cable is already fixed to the reader.
► Slide the drive into the bay (1).
56 Fujitsu
To Next Page
Loading...
