System expansions
It may be necessary to modify the entry for the drive in the BIOS Setup.
Installing and removing a 2½ inch drive (screw fastened)
Installing a drive
► Remove the casing cover (see chapter "Removing the casing cover" , Page 35).
► Fold out the drive cage (see chapter "
Opening the drive cage", Page 46).
2
1
► Slide the drive into the bay (1).
► Secure the d
rive with the screws (2).
► Connect the cables at the drive and at the mainboard . M ake sure the polarity is correct.
► Fold the dr
ive cage into the closed position again (see chapter "
Closing the drive cage", Page 47).
► Fit the casing cover onto the casing again (see chapter "
Reattaching the casing cover.", Page 36).
If necessary, you must adjust the e ntry for the drive accordingly in the BIOS Setup.
54 Fujitsu
To Next Page
Loading...
