System expansions
5
4
5
► Fasten the serial port with the screws (4).
► Connect the cab
le to the mainboard (5).
► Refit the casing cover on the casing (see chapter "
Reattaching the casing cover.", Page 3 6).
To remove, perform the above steps in reverse order. To comply with the electromagnetic
compatibility (EMC) regulations, secure the metal plate at the installation opening again.
Installing a parallel port
Depending on the configuration level of your device, there may be an installation opening intended
for a parallel port on the rear panel of the device. As a result, no board slot is occupied.
► Remove the casing cover (see chapter "
Removing the casing cover", Page 35).
► Remove the board carrier from the casing (see chapter "
Removing a board carrier", Page 62).
72 Fujitsu
To Next Page
Loading...
