System expansions
Removing a 3½ inch drive
► Remove the casing cover (see Chapter "Removing the cas ing cover", Page 35).
► Fold out the drive cage (see Chapter "
Opening the dri ve cage", Page 46).
► Disconnect any cables con nect ed to the drive.
1
2
b
a
► Undo the screws (a or b, depending on the type of drive).
► Push the drive a few centimetres out of the bay in the direction of the arrow (1).
► Pull the drive completely out of the bay in the direction of the arrow (2).
► If you are not installing a new drive , chan ge the drive cover if necessary (see
chapter "
Changing the drive cove r", Page 38).
► Fold the drive cage into the closed position again (see chap ter "
Closing the drive cage", Page 47).
► Fit the casing cover onto the casing again (see chapter "
Reattaching the casing cover.", Page 36).
If necessary, you must adjust the e ntry for the drive accordingly in the BIOS Setup.
58 Fujitsu
To Next Page
Loading...
