Fujitsu CELSIUS J550 - 2.5-inch Drive Installation and Removal; Installing and Removing 2.5-inch Drives with Adapter

System expansions
Installing and removing 2½ inch drives in
a 3½ inch adapter
You can install two non-accessible 2½ inch drives with a 3½ inch adapter in th e lower and middle bays.
Installing 2½ in ch driv es in a 3½ inch adapter
EasyChange rails for both drives are in the adapter.
a
► Fasten the EasyChange rails to the side of the first drive by inserting each pin of the
EasyChange rail in the corresponding holes on the drive. In doing so, make sure that
the ports on the drive are located at the rear as shown (a).
► Repeat the step for the second drive.
48 Fujitsu