System expansio ns
Installing the heat sink
2
1
► Insert the heat sink into the casing (1). In doing so, correctly align the screw holes on the
heat sink with the screw holes on the mainboard. In the process, the fan on the heat sink
must point towards the inside of the casing / away from the front of the casing.
► Tighten the screws (2) in a crosswise fashion.
3
a
► Place the cowl in the casing (3) at a slight angle and take care that the pins
(a) fit into the openings in the casing as shown .
The cowl engages at the location marked "PULL".
► Connect the fan cables to the mainboard.
► Fit the casing cover back onto the casing (see Chapter "
Reattaching the casi ng cover.", Page 36).
Fujitsu 77
To Next Page
Loading...
