System expansio ns
Removing a drive
► Remove the casing cover (see chapter "Removing the casing cover", Page 35).
► Fold out the drive cage (see chapter "
Opening the drive cage", Page 46).
► Disconnect any cables that are connected to the drive.
1
3
2
► Undo the screws (1).
► Push the drive a few centimetres out of the bay in the direction of the arrow (2).
► Pull the drive completely out of the bay in the direction o f the arrow (3).
► Fold the drive cage into the closed position again (see chapter "
Closing the drive cage", Page 47).
► Fit t he casing cover onto the casing again (see chapter "
Reattaching the casing cover.", Page 36).
If necessary, y ou must adjust the entry for the drive a ccord ingly in the BIOS Setup.
Fujitsu 55
To Next Page
Loading...
