Important notes
Cleaning the device
Device,Tr anspor tationRetransportationSystemunit,see Device
Turn off all power and equipment switches and disconnect the p o wer
plug from the m ains outlet.
Do not clean any interior parts yo urself, leave this job to a s ervice technician.
Do not use any cleaning agents that contain abrasives or may corrode
plastic (alcohol, thinner or ace tone).
Never clean the device with water! Water en tering into the device c ould
present a serious risk to users (e.g. electric shock).
Ensure that no liquid enters the system.
Thesurfacecanbeclea
ned with a dry cloth. If particularly d irty, use a cloth that has been
moistened in mild dome
stic detergent and then carefully wrung out.
Use disinfectant wi
pes to clean the keyboard and the mouse.
Energy saving, disposal and recycling
DisposalEnergysavingRecycling
You c an find information on the se subjects in the "Environment a nd Energy Information" manual
or on our website ("
http://www.fujitsu.com/fts/about/fts/environ ment-care/").
Note on the European Ecodesign Directive
The hibernate
state (Advanced Configuration and Power Interface ACPI S4 Save-to-disk) is
not available
for workstations in certain configurations. As a consequence, it is not possible
for these sys
tems to switch off automatically according to the Ecodesign directive.
With a workin
g memory expansion wh ich exceeds the free capacity of the s ystem drive, the
capability
to enable the hibernate state (ACPI S4) is technically not possible.
With suita
bly larg e system drives, the off state is automatically enabled in the
settings w
ith which these workstations are delivered.
Fujitsu 13
To Next Page
Loading...
