Fujitsu CELSIUS M770 - Removing the M.2-Module on the Mainboard

System expansions
Removing the M.2-module on the mainboard
► Open the casing (see "Open the casing", Page 43).
► R emove the boards (see "
Removing a board", Page 85).
b
a
2
1
► U ndo the screw (1).
► Pull the M.2 module (b) slightly at an angle in the direction of the arrow (2) and o ut
of the slot (a) on the m ainboa rd and remove it fro m the casing.
► For safe keeping, secure the screw for retaining the M .2 module on one of
the associated stud bolts on the mainboard.
► In stall the boards (see "
Installing a board", Page 87).
► C lose the casing (see "
Close the casing", Page 44).
If necessary, you must adjust the entry for the M.2 m odule accordingly in the BIOS Setup.
82 Fujitsu