System expansio ns
Install the M.2 module on the front panel module (optional)
► Open the casing (see "Open the casing", Page 43).
► Remove the front panel module (see "
Removing the front panel module", Page 51).
b
a
1
2
► Insert the M.2 module (b) at a slight an g le in the d irection of the arrow (1)
into the slot (a) on the front panel module.
► If the screw for retaining the M.2 module is located on o ne of the associated stud
bolts on the front panel module, remove the screw.
► Secure the M .2 module on the front panel module with the screw (2). In doing so,
select the stud bolt appropriate to the length of the module.
► Install the front panel module (see "
Installing the front panel module" , Page 53).
► Close the casing (see "
Close the casing", Pag e 44).
If necessary, you must adjust the entry for the M.2 module accordingly in the BIOS Setup.
Fujitsu 83
To Next Page
Loading...
