Rack mounting (optional)
3rd party racks
Installation in most curren t rack systems from other manufacturers (3rd party racks) is
supported. For more information, contact your responsible sales person.
Preparation for rack mounting
Before mounting in the rack, you must fit one rack pan el on the top and one on the bottom of the
CELSIUS. These are unmistakably shaped and can only be fitted to the associated face.
The rack pan els and rails are included in the scope of the delivery.
The device m ust be switched off when installing/removing system expansions
and must not be in energy saving mode.
► Sw itch the device of
f.
► R emove all the cables from the device.
► La y the device as sh
own below, on a stable, flat and clean surface. If necessary, place a
slip-resistant cl
oth on this surface to prevent the device from being scratched.
1
1
1
2
► Remove the screws (1).
► Lift the casing cover off the casing (2).
24 Fujitsu
To Next Page
Loading...
