System expansio ns
Installing the heat sink
Never operate the device without the heat sink fitted!
Before initial s tartup, install the heat sink again in the same way as it was
installed in the d evice before removal. The air flow direction is indicated by
an arrow on the heat sink. Install the heat sink so that the arrow for the
air flow direction points towards the rea r panel.
2
2
2
2
2
a
► Insert the heat sink into the casing (1). In doing so, correctly align the screw holes
on the heat sink with the screw holes on th e mainboard (2).
► Tighten the screws (a) with a torque of 1 Nm.
► Install the ventilation duct (see "
Install ventilation duct", Page 48).
► Close the casing (see "
Close the casing", Pag e 44).
Fujitsu 95
To Next Page
Loading...
