Troubleshooting and tips
The device cannot be switched off w ith the ON/OFF switch.
Cause
Remedy
System crash ► Ke ep the on/off switch pressed for at least 4
seconds until the machine switche s off.
Caution: This can lead to a loss of data!
This procedure does not allow the operating
system to shut down in an orderly way. The next
time the system is started there may well be
error messages.
Monitor remains blank
Cause
Remedy
Monitor is switched off ► Sw itch your monitor on.
Power saving h as been activated (screen is
blank)
► Press any key on the ke yboard.
or
► D e ac tivate the screen saver. If
necessary, enter the appropriate
password.
Brightness control is set to dark ► Ad just the brightness control. For detailed
information, please refer to the operat ing
manual supplied with your m onitor.
Power cable not connected
► Sw itch off the monitor and the device.
► C heck that the monitor power cable is
properly connected to the monitor and to
a grounded mains outlet or to the monitor
socket of the device.
► C heck that th e device power cable is
properly plugged into the device and a
grounded mains outlet.
► Sw itch on the monitor and the device.
Monitor cable no t connected
► Switch of
f the monitor and the device.
► C heck that the monitor cable is p roperly
connected to the device and monitor.
► Switch o
n the monitor and the device.
Incorrect setting for the monitor
► Restar
t the system.
► Press
F
8
while the system is booting.
► Start
the system i n Safe Mode.
► Se t up the monitor as described in the
documentation for your operating system
and monitor.
Fujitsu 37
To Next Page
Loading...
