Troubleshooting and tips
The device cannot be switched off w ith the ON/OFF switch.
Cause
Remedy
System crash ► Keep the on/off switch pressed for at least 4
seconds until the machine switche s off.
Caution: This can lead to a loss of data !
This procedure does not allow the operating
system to shut down in an orderly w ay. The next
time the system is started there may well be
error messages.
Monitor remains blank
Cause
Remedy
Monitor is switched off. ► Switch your monitor on.
Power saving h as been activated (screen is
blank)
► Press any key on the keyboard.
or
► Deac tivate the screen saver. If
necessary, enter the appropriate
password.
Brightness control is set to dark ► Adjust the brightness control. For detailed
information, please refer to the operat ing
manual supplied with your monitor.
Power cable not connected
► Switch off the monitor and the device.
► Check that t he m on itor pow er cable is
properly connected to the monitor and to
a grounded mains outlet or to the monitor
socket of the device.
► Check that th e device power cable is
properly plugged into the device and a
grounded mains outlet.
► Switch on the monitor and the device.
Monitor cable no t connecte d
► Switch of
f the monitor and the device.
► Check that the m onitor cable is properly
connected to the device and monitor.
► Switch o
n the monitor and the device.
Incorrect setting for the monitor
► Restar
t the system.
► Press
F
8
while the system is booting.
► Start
the system in Safe M ode .
► Set up the monitor as described in the
documentation for your operating system
and monitor.
Fujitsu 29
To Next Page
Loading...
