System expansio ns
► Connect the cables to the hard disk drive.
It may be necessary t o modify the entry for the drive in the BIOS Setup.
Removing a hard disk
The principles for installing/removing hard disks for the device as described below are identical
for all types of hard disk. Only the size and alignment of the hard disk in the casing may
vary (install either horizontally or vertically depending on the hard disk type).
The following images illustrate the installation of a 3
1
/
2
" drive.
In additio n, the EasyChange rails are different on 2
1
/
2
inch drives and 3
1
/
2
inch drives.
Removing the hard disk drive
► Disconnect the cables connected to the ha rd disk drive.
1
1
2
► Press the levers of the EasyChange rails attached to the hard d isk drive
outwards (1), until the hard disk is released.
► Pull the hard disk drive out of the drive cage in the direction of the arrow (2).
Fujitsu 59
To Next Page
Loading...
