System expansions
Securing the hard disk front panel
1
► Place the hard d
isk front panel in the guide openings as illustrated.
► Fold the hard disk front panel in the direction of arrow (1) until you feel it engage.
Remove and install type 1 boards
You can insta
ll additional modules in order to increase the performance of your machine.
The number,
position and arrangement of the board slots on the mainboard can be found in
the manual
for the mainboard. Boards may already be installed on shipment.
Type 1 boar
ds are installed at the lower rear area inside th e casing.
If you ha
ve already inst alled a type 2 board, you must firstofallremoveit,
see "
Re
move and install t ype 2 boards", Pag e 73
Board
,
Board
,
Perform board installation
If you
wish to install a type 1 board, you must first remove the board fan
and a
ny type 2 boards which are present from the cross-piece. Then fold the
cros
s-piece upwards so that you can install the board.
Thi
s preliminary work is described in the following sections.
62 Fujitsu
To Next Page
Loading...
