System expansio ns
Installing and removing the accessible 5
1
/
4
inch
drive (Ultra Slim, top drive b
ay)
The following instructions apply only to the installation and removal of an
accessible drive in Ultra Slim format, in the top drive bay.
Installing an accessible drive
2
3
2
1
► Remove the
screws (1).
► Push the drive carrier a few centimetres out o f th e casing in the direction of the arrow (2).
► Pull the d
rive carrier completely out of the casing in the direction of the arrow (3).
Do not di
spose of the cover of the Ultra Slim drive bay. For cooling and
protect
ion against fire you must refit the cover if you remove the drive again
later (s
ee "
Removing an accessible drive", Page 41).
► Remove the co ver of th e Ultra Slim drive bay.
Fujitsu 35
To Next Page
Loading...
