System expansio ns
Installing and removing the accessible 5
1
/
4
inch
drive (standard size, bottom
drive bay)
The following instructions apply only to the installation and removal of an
accessible drive in stand ard size, in the bottom drive bay.
Fitting the drive cover for the 5
1
/
4
inch drive
• Requirement: The casing is open (see section "Opening the casing", Page 33).
To use the latch function of the accessible 5
1
/
4
inch drive, you must fit the corresponding
drive cover before installing th e drive in the casing. Proceed as follows:
2
3
1
► Un lock the drive cover (1).
► Pu sh the
drive metal plate upwards (2) so it is released from the catches with which it is se cured.
► Lift the drive cover away from the casing (3).
1
► Connect
thedrivecovertothedrive(1).
Fujitsu 39
To Next Page
Loading...
