System expansio ns
Screwing the reader onto the module holder
2
2
a
a
1
► With the component side facing downwards,
slide the reader in the direction of arrow (1)
into the guide on the module holder (a).
► Fasten the reader with the screws (2).
Installing a module holder with reader
1
2
2
1
► Push the module holder into the casing in the direction of the arrow ( 1) until the screw holes
on the casing and the screw holes on the reader are d irectly one above the other (1).
► S ecur
e the module holder with the screws (2).
► Connect the cables to the boards and the mainboard. Make sure the polarity is correct.
► Clos
e the casing (see "
Closing the casing" , Page 34).
Fujitsu 43
To Next Page
Loading...
