System expansions
Removing a module holder w ith reader
• Requirement: The casing is open (see "Opening the casing", Page 33).
► Disconnect the cables connected to the module holder.
1
1
1
3
2
► Remove the screws (1).
► Push the module holder a few centimetres out of the casing in the direction of the a rro w (2).
► Pull the m odule holder completely out of the casing in the direction of the arrow (3).
► Remove the reader from the module holder ( see "
Removing the reader from
the module h older", Page 45) and reinstall the mod ule holder (corresponds to
"
Installing a module holder with re ader", Page 43).
or
► Remove the reader from the module holder (see "
Removing the reader from the
module h older", Page 45) and install a blind cover in the d rive bay.
► Close the casing (see "
Closing the casing" , Page 34).
44 Fujitsu
To Next Page
Loading...
