System expansions
Remove card holder
To be able later to connect the cables of the hard drive at the mainboard,
you must remove the card holder.
2
1
► Press the catch of the card holder in the direction of the arrow (1) so
that it releases from the location.
► Fold the card holder upwards to the stop.
► Unhinge the card holder from the casing (2).
► Remove the card holder from the casing.
Replacing the assembly kit
• Requirements:
There are not any hard disk drives inst alled in the drive bays.
Otherwise you must first remove the hard disk drives.
• The casing is open (see "
Opening the casing", Pa ge 33).
If you wish to use an installation kit for your hard disks which is other than that which
was installed in your device in the factory, proceed as follows:
Only the relevant compo nents are shown in the following illustrations
for reasons of simplification.
► If any hard disk drives are already installed, remove them (see "
Removing a hard disk", Page 59).
► If ne
cessary, disconnect the drive cables from the installation kit:
Press the catch to unlock it and press the cable retainer backwards out of the opening.
52 Fujitsu
To Next Page
Loading...
