System expansio ns
Install the cross-piece
2
1
► Fit the cross-piece and connect the fan cables.
► Fold the cross-piece down (1) and make sure that the catches engage in
the openings provided for them (2).
Make sure that no cables become pinched.
► Fit the hood (device-dependent).
► Secu re all the cables pre viously detached.
► If a type 2 board w a s installed and it was secured to the cross-piece, install the latter
again (see "
Remove and install type 2 boards", Page 73 ).
Fujitsu 71
To Next Page
Loading...
