ETERNUS DX60/DX80/DX90 Disk storage system User Guide
136
Copyright 2010 FUJITSU LIMITED
P3AM-3042-06ENZ0
Chapter 7 Setup
This chapter explains how to set up the ETERNUS DX60/DX80/DX90.
7.1 Setup Preparation
The following preparations are required before starting the ETERNUS DX60/DX80/DX90 setup:
• Related manuals
• Network setting information
• Completing and attaching the Network Settings label
• Preparation and settings for the PC
■ Related manuals
Prepare the following manuals:
❏ "ETERNUS DX60/DX80/DX90 Web GUI User Guide"
❏ "ETERNUS DX Disk storage systems Server Connection Guide"
❏ Other related manuals, for example, for a server or networking equipment to be connected to
the ETERNUS DX60/DX80/DX90.
■ Network setting information
Determine the following network settings:
❏ IP address and subnet mask for the ETERNUS DX60/DX80/DX90's MNT port of Master CM
(required)
Default IP address: 192.168.1.1
Default subnet mask 255.255.255.0
❏ IP address and subnet mask for the ETERNUS DX60/DX80/DX90's MNT port of Slave CM
No default value is set.
This setting is required when enabling the MNT port of a Slave CM for dual controller model.
For the dual controller model, the controller through which the
ETERNUS DX60/DX80/DX90 is set up and operated is called the
"Master CM", while the other controller is called the "Slave CM".
The single controller model only has a "Master CM" controller.
For dual controller model, from the MNT port of Slave CM, the device
status can be displayed, and a Master CM is switched to a Slave CM.
To Next Page
Loading...
