Fujitsu Eternus DX90 - Additional Drive Enclosure Installation; Figure 8.3 [Add Drive Enclosure] Initial Screen

Chapter 8 Installing Optional Products
> 8.2 Drive Enclosure Installation
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
198
Copyright 2010 FUJITSU LIMITED
P3AM-3042-06ENZ0
8.2.4 Additional Drive Enclosure Installation
This section describes how to install a drive enclosure for the ETERNUS DX60/DX80/DX90.
Procedure
1 First check that all the components of the ETERNUS DX60/DX80/DX90 are in
normal status, using the Storage System Status screen of GUI.
2 Wear a wrist strap.
For how to wear a wrist strap, refer to "3.6 Wearing the Wrist Strap" (page 81).
3 Click [Add Drive Enclosure] under the [Hardware Maintenance] menu on the
[Maintenance] tab in the GUI screen.
The [Add Drive Enclosure] initial screen appears.
4 Click the [Next >] button.
Figure 8.3 [Add Drive Enclosure] initial screen