Chapter 7 Setup
> 7.2 Basic Setup
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
162
Copyright 2010 FUJITSU LIMITED
P3AM-3042-06ENZ0
Procedure
1 In the GUI screen, click [Assign Hot Spare] under the [RAID Group
Management] menu on the [Volume Settings] tab.
The [Assign Hot Spare] screen appears.
2 Select the hot spare type and the disk to be used as hot spare, and click the
[Assign] button.
The following is a setting example when "Global Hot Spare" is selected.
When selecting "Dedicated Hot Spare" as the hot spare type, "Select an existing RAID
Group" appears.
Figure 7.23 [Assign Hot Spare] screen
A confirmation screen appears.
3 Click the [OK] button.
The hot spare is registered.
End of procedure
This ends the basic settings.
If further setup is necessary, refer to the "ETERNUS DX60/DX80/DX90
Web GUI User Guide".
To Next Page
Loading...
