Fujitsu Eternus DX90 - E-Mail Notification Setup; Figure 7.34 [Setup E-Mail Notification] Screen (Notification E-Mail)

Chapter 7 Setup
> 7.4 Monitoring Setup
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
172
Copyright 2010 FUJITSU LIMITED
P3AM-3042-06ENZ0
10 After the necessary settings have completed, click the [Set] button.
A confirmation screen appears.
11 Click the [OK] button.
The specified event notification setting is enabled.
End of procedure
7.4.2 E-mail Notification Setup
If an error occurs in the ETERNUS DX60/DX80/DX90, the event (error information, etc.) is
reported to a specified address.
The procedure to set the E-mail notification is as follows:
Procedure
1 Start GUI.
2 Click [Setup E-Mail Notification] under the [Network Settings] menu on the
[Global Settings] tab in the GUI screen.
The [Setup E-Mail Notification] screen appears.
3 Set the necessary items in the [Notification E-Mail] area.
• Select "Enable" in "Notification E-Mail".
• Specify the E-mail destination address in "Destination E-Mail Address".
Figure 7.34 [Setup E-Mail Notification] screen (Notification E-Mail)
4 Click the "Mail Server Settings" link.
The [Mail Server Settings] screen appears.