EasyManua.ls Logo

Fujitsu Eternus DX90 - Figure 2.20 Front View of 3.5 Type Drive Enclosure (Without Front Cover); Figure 2.21 Disk Slot Numbers of 3.5 Type Drive Enclosure

Fujitsu Eternus DX90
239 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 2 Components
> 2.3 3.5" Type Drive Enclosure
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
64
Copyright 2010 FUJITSU LIMITED
P3AM-3042-06ENZ0
Without front cover
Figure 2.20 Front view of 3.5" type drive enclosure (without front cover)
Disk slot numbers
Figure 2.21 shows the slot numbers of the disks in the drive enclosure.
Figure 2.21 Disk slot numbers of 3.5" type drive enclosure
AUTO POWER Switch
The AUTO POWER Switch of the
drive enclosure is set to "OFF" by
default, and should not be set to "ON".
MODE SELECT Switch
Enables the device power to be turned
on via power linkage
This switch is set to "ON" by default,
and should not be set to "OFF".
This is not used.
DE_No. label
Indicates the drive enclosure No.
DISK READY/FAULT LED
Glows ( ) or blinks green ( ) when disks
are operating normally.
Glows orange ( ) when a disk has failed.
Blinks orange ( ) according to the VDS (Microsoft Virtual Disk Service) commands.
Disk
Up to 12 can be installed in
the ETERNUS DX60/DX80/DX90.
Slot#0
Slot#4
Slot#8
Slot#1
Slot#5
Slot#9
Slot#2
Slot#6
Slot#10
Slot#3
Slot#7
Slot#11

Table of Contents

Other manuals for Fujitsu Eternus DX90

Related product manuals