Chapter 7 Setup
> 7.4 Monitoring Setup
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
169
Copyright 2010 FUJITSU LIMITED
P3AM-3042-06ENZ0
7.3.3 Advanced Copy Settings
For settings and operations to use the Advanced Copy functions, refer to "ETERNUS DX60/
DX80/DX90 Web GUI User Guide" or "ETERNUS DX60/DX80/DX90 CLI User Guide".
For operation settings when using ETERNUS VSS Hardware Provider, refer to the ETERNUS
VSS Hardware Provider manual.
7.4 Monitoring Setup
Perform the ETERNUS DX60/DX80/DX90 monitoring setup if required.
7.4.1 Event Notification Setup
Set how to notify of an event and its level when a problem occurs in the ETERNUS DX60/DX80/
DX90.
Procedure
1 Start GUI.
Refer
"ETERNUS DX60/DX80/DX90 Web GUI User Guide"
"ETERNUS DX60/DX80/DX90 CLI User Guide"
"ETERNUS VSS Hardware Provider manual"
This section explains the procedure for the setup using GUI. For setting-
related details, refer to the "ETERNUS DX60/DX80/DX90 Web GUI User
Guide".
For the setup using the CLI commands, refer to "ETERNUS DX60/DX80/
DX90 CLI User Guide".
Refer
"ETERNUS DX60/DX80/DX90 Web GUI User Guide"
"ETERNUS DX60/DX80/DX90 CLI User Guide"
There are four methods to notify of an event: E-Mail, SNMP trap, host
sense, and REMCS (only for the ETERNUS DX90).
When notifying of an event by E-mail, "Setup E-Mail Notification" must be
set. When notifying of an event by the SNMP trap, "Setup SNMP Agent"
must be set. Refer to "ETERNUS DX60/DX80/DX90 Web GUI User Guide"
for details of the settings.
Refer
"ETERNUS DX60/DX80/DX90 Web GUI User Guide"
To Next Page
Loading...
