Fujitsu Eternus DX90 - Attaching and Removing the Flange Cover

Chapter 3 Standard Operations
> 3.4 Attaching and Removing the Flange Cover
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
78
Copyright 2010 FUJITSU LIMITED
P3AM-3042-06ENZ0
3.4 Attaching and Removing the Flange Cover
This section explains how to attach and remove the flange cover of the 2.5" type controller
enclosure and the 2.5" type drive enclosure.
■ Procedure for attaching the flange cover
Attach the flange cover in the following order.
Procedure
1 Slide the tab inside the top of the flange cover over the top-left corner of the controller
enclosure.
CAUTION
Do
• At the completion of this operation, check that the flange cover is
attached.
This section explains how to attach and remove the flange cover of the 2.5"
type controller enclosure, but the same procedure is used to attach and
remove the flange cover of the 2.5" type drive enclosure.
I
MPORTAN
T
When fitting the flange cover, be careful not to touch the power
switch ( ).
Flange cover