Fujitsu Eternus DX90 - Figure 7.19 [Define LUN Mapping] Screen 1 (When the Host Affinity Function Is Used); Figure 7.20 [Define LUN Mapping] Screen 2 (When the Host Affinity Function Is Used)

Chapter 7 Setup
> 7.2 Basic Setup
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
158
Copyright 2010 FUJITSU LIMITED
P3AM-3042-06ENZ0
6 Configure a LUN mapping.
Set a volume to be recognized by the server.
■ When the Host Affinity function is used
Assign an affinity group to each server that is to be connected to the port.
(1)Select the port to be set from the "Port List" field, and click the [Edit] button.
Figure 7.19 [Define LUN Mapping] screen 1 (when the Host Affinity function is used)
(2)Assign the affinity group to the server, and click the [Set] button.
Figure 7.20 [Define LUN Mapping] screen 2 (when the Host Affinity function is used)
A confirmation screen appears.
(3)Click the [OK] button.
The affinity group is created, and the screen returns to the screen displayed in Step (1)
.
Set other affinity groups as required.
(4)Click the [Exit] button.
The settings are reflected, and a message to confirm finishing the Configuration Wizard
appears.