Chapter 3 Standard Operations
> 3.1 Power ON Control
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
73
Copyright 2010 FUJITSU LIMITED
P3AM-3042-06ENZ0
Procedure
1 Press the power switch ( ) of the controller enclosure.
Controller enclosure POWER LED turns on.
2 After a few minutes, check that controller enclosure’s READY LED is lit up.
3 Check that all enclosure’s POWER LED and READY LED are lit up.
End of procedure
When drive enclosures are installed, the power turns on
automatically.
Controller enclosure
Drive enclosure
Drive enclosure
Power switch
Controller enclosure
Drive enclosure
Drive enclosure
LED for
drive enclosure
LED for
controller enclosure
To Next Page
Loading...
