Fujitsu fi-6800 - Page 143

Index
Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Contents
TOP
143
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Replacing
Consumables
Scanner
Overview
Operational
Settings
Paper Protection Specify whether to enable or disable
Paper Protection.
Enabling this setting reduces the
risk of having the documents
damaged upon feeding errors, by
stopping the scan when the scanner
detects a document that is unusually
warped.
Paper Protection is disabled in
Manual Feed mode.
It can also be configured from the
scanner driver’s setup dialog box or
the operator panel. Note that priority
is given to the scanner driver setting
unless you have prioritized the
operator panel setting.
Enable / Disable Disable

Paper Protection
Sensitivity
You can specify the level of
sensitivity to detect an abnormal
feeding of documents when Paper
Protection is enabled.
It can also be configured from the
operator panel. Note that you can
prioritize the operator panel setting.
Low / Normal / High Normal

Scan Setting for
Document with Tab
(Automatic Page
Size Detection)
For documents with index tabs or
index stickers attached on the
bottom of the page, you can keep
the tab (index or index stickers) on
the scanned image when scanning
in Automatic Page Size Detection.
Specifying [Document with tab]
shows the image of the tab, but
slows down the scanning speed.
SCSI or USB Connector:
Document with tab / Document without
tab / Non-rectangular document
VRS board (optional) connection:
Document with tab / Document without
tab
Document
without tab

Item Description Setting/Value Factory Default SCSI or USB
Connector
VRS board (optional)
connection
: Configurable
-: Not configurable