Index
Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Contents
TOP
144
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Troubleshooting
Replacing
Consumables
Scanner
Overview
Operational
Settings
Scan Setting for
Document in Dark
Background Color
Configure this setting when the
edges of a document with dark
background color are falsely
detected. You can specify the level
of sensitivity to accurately detect the
edges of documents with dark
backgrounds.
Enable / Disable
Density of background color: Level 1 to 5
Disable -
Overcrop/
Undercrop
Adjust the size of the scanned
document output image detected in
Automatic Page Size Detection.
Overcrop: 0 to 5 mm
(in increments of 1 mm)
Undercrop: -5 to 0 mm
(in increments of 1 mm)
0 mm -
Maintenance and
Inspection Cycle
Specify the cycle for scanner
maintenance and inspection to be
performed by a service engineer.
When the specified time period
elapses since the last periodical
maintenance and inspection, a
message for periodical maintenance
appears.
Disable / Enable
Maintenance/Inspection cycle: 1 to 12
months
Disable
Multi dropout
colors
Specify a color to be dropped out
from the scanned image (black &
white/grayscale mode only). You can
select any color(s) to drop out in
[Multi dropout colors].
Note that priority is given to the
scanner driver setting if any dropout
color has been specified in the
scanner driver’s setup dialog box.
Use driver settings / Custom Use driver
settings
-
Overscan Control Outputs the image in the optimum
position when the image is partially
missing due to a large skew.
Normal / Optimize
Black frame thickness: Thin (Default) to
Thick (level 1 to 3)
Normal
-
Item Description Setting/Value Factory Default SCSI or USB
Connector
VRS board (optional)
connection
: Configurable
-: Not configurable
To Next Page
Loading...
