Working with the notebook
Installing a module
► Place the modu le into th e module bay so that the contacts enter first.
► Push the module into the module bay until yo u feel it locking into place.
Optical drive
Opticaldrive
This product contains a light emitting diode, classified in accordance w ith IEC
8251:1993: LASER CLASS 1, and must therefore not be opened.
Handling data carriers
Handling
Observe the following guidelines when handling data carriers:
• Avoid touching the surface of a data carrier. Only handle data carriers by their edges.
• Always store data carriers in their cases. This will protect the data carrier against
being covered in dust, scratched or damaged in any other way.
• Protect your data carriers against dust, mechanical vibrations and direct sunlight.
• Avoid storing a data carrier in areas subject to high temperatures or humidity.
You may use both 8-cm and 12-cm data carriers in the optical drive.
When using a data carrier of lesser quality, vibrations and reading errors may occur.
CD/DVD indicator
CD/DVD
indicator
The CD/DVD indicator flashes when a data carrier is inserted. The indicator goes out when
the drive is ready for reading. The indicator lights up when the drive is being accessed.
You may on ly remove the data carrier when the indicator is unlit.
If the CD/DVD indicator does not go out aft er a data carrier has been inserted, b ut
instead continues to flash, this means that the drive cannot access the data carrier.
Either the data ca rrier is damaged or dirty or y ou are using a data
carrier that the drive cannot read.
56 Fujitsu Technology Solutions
To Next Page
Loading...
